scc foot pedal

[WookieWelding]

I am going to be ordering a scc controls foot pedal for my 250 ac dc longevity tig
my Question is does longevity stock just the 7 pin plug in or is there somewhere i can get it and also what is the ohm value for the pot in the Longevity pedals and the Pin out


This is the pedal i am getting
TIG (GTAW) Welding Foot Control Pedal

[KHK]

Chech out this link
Foot Switch 200pi - FreeWeldingForum.com Welding Gallery

Longevity had the 7 pin plug at one time. Give them a call, I am sure that they can help.

[LONGEVITY-Support]

KHK that is correct, Longevity does carry the 7 pin connector foot pedals

[SICFabrications]

i think he is only looking for the pin connector itself separately and not the whole controller.... wookie, i found a junk synchrowave at eh scrapyard (machine was toast, they let the smoke outta the wires and transformer) and swapped the 7-pin longevity for the 14-pin miller and put the miller pedal on the 200PI.... now, it works like a pedal should.....

[WookieWelding]

i think he is only looking for the pin connector itself separately and not the whole controller.... wookie, i found a junk synchrowave at eh scrapyard (machine was toast, they let the smoke outta the wires and transformer) and swapped the 7-pin longevity for the 14-pin miller and put the miller pedal on the 200PI.... now, it works like a pedal should.....

What i am needing is the Ohm value for the pot in the Longevity pedal so i can order a scc pedal and a 7 pin end so i can plug in my new scc controls pedal into the machine

[KHK]

Chech out this link
Foot Switch 200pi - FreeWeldingForum.com Welding Gallery

Longevity had the 7 pin plug at one time. Give them a call, I am sure that they can help.

The ohmic value is at the bottom of the page. It is 50K ohms

[JolietJames]

Hi Keith. Where in the Chicago burbs are you?
Thanks, -James

[KHK]

Hi Keith. Where in the Chicago burbs are you?
Thanks, -James

I am in ITASCA about 7 miles west of O'Hara

[JolietJames]

Ok thanks. Do you stock cover plates for the helmets or do I need to find out where I can get them and order directly? Actually I should place an order if I can find them because shipping will cost less than the gas to drive to Itasca.
-James

[WookieWelding]

The ohmic value is at the bottom of the page. It is 50K ohms

thanks you keith now i just need to get the 7 pin plug

---------- Post added at 04:07 PM ---------- Previous post was at 04:01 PM ----------

if anyone wants a scc pedal this is the special order number The special order # is L50000. same as everlast machines its about 138 bucks
i now need to know the pin out for the 7 pin plug i so it can be wired up