Specifications:General Specifications:
Genuine: Siemens Infineon IGBT based electronics
Operating Voltage: 220/230/240 VAC 50/60Hz Input
Open Circuit Voltage: 70V
60% Duty Cycle @ Rated Amps
Weight: 60 lbs
Thermal Overload Protection with Large Size Cooling Fan
Size: 21.5" L x 8 3/4"W x 15.25" H (with handles )inches
20-60AMP Plasma Cutting Specifications @ 60psi:
3" Per minute @ 1 " Steel (Severance Cut )
7" Per minute @ 3/4" Thick Steel
17" Per minute @1/2" Thick Steel Minimum requirement for air compressor: (4.0 CFM)
5-250AMP AC/DC TIG Features: Up Slope, Down Slop Control: 0-10 Seconds
Post Flow Control: 0-25 Seconds
Base Current Control: 5-250 Amps
Peak Pulse Current Ratio: 10- 250 Amps
Pulse Frequency Control: .0.2-300 Hz
Pulse Width Control: 10%-90%
AC Frequency Control: 50-250 Hz
AC Balance Control: 30-70% (for Aluminum)
After Flow Time: 1-25s
Rated Duty Cycle: 35%
Arc Starting Mode: High Frequency/Lift Arc Striking
10-200AMP Stick Features:
Arc Force Controls the amperage from 0-10 to push an E6010 Stick Rod.
No Load Voltage: 70V
Rated Duty Cycle: 60%
Rated Output Current: 200 AMP
Pilot Arc and Contact Start:
Pilot Arc plasma cutter starting technology allows you to start and maintain an ARC as long as the trigger is pressed. This ARC is a similar to the ARC you will see from an oxy fuel cutting torch. In addition, you are able to hook these torches up to CNC machines because contact with the workpiece and the tip of the torch is not required. Also because there the starting technology is not High Frequency, your plasma cutter does not interfere with CNC Computers. Pilot Arc torches also have longer consumable life because you can maintain a distance when starting an arc.
Operating Voltage:
220V Single-phase input at 50 or 60 Hz.
Features:
High powered stainless steel, corrosion free water pump
Quick fill and drain 9 liter water reservoir
Big front mounted radiator
200mm large rear mounted fan to support cooling system
The dimensions are 18” L x 10.5” W x 12” H for the water cooler.
1 liter per minute cooling capacity!
No water leakage guarantee!
- Heavy Duty MIG/TIG/FLUX Welding Cart
- Over All Size: 28-1/2" H x 28" L x 11-1/2" W
- Assembling Required
