I have never used 7014, but I hear they run a lot like 6013. I hate 6013. 1/8 7018 is my fav rod, I will post some pictures of some t-welds I did with t...
Sorry to keep asking all of these newbie questions but ... I know each rod has their own characteristics but I'm not really looking to buy a whole inve...
Flap disk. Probably 80 grit or higher so it won't leave much in the way of scratches. Just brushes right off. If you want to get the dust off you can ...
I just did this to my welding table. I used a wire wheel in a makita 5 inch grinder. If I had a wire wheel for my 7 inch, I would have used that. Just b...
I am not sure, but I recall hearing that a rod is fine as long as the metal under the flux isnt rusty. Also, if you have 6010 or 6011 that wont run well...
I do it all the time with my stickweld 250. I glanced down at the display, and it read 170 amps, I had it set at 125. Not sure if it was right, or it wa...
